If your TV tunes to Channel 3, go to step 23. Light does not flash at all, go back to stepĢ2.Press. SAT light flashes three times, go to step 22. (Fill in this blank with the exact sequence you circled in Table 1)Ģ0.Press the MUTE button while watching SAT light. Press the 0 through 9 buttons to change channels on your TV.ġ6.Write the number(s) you circled into the blank in step 19.Try the other buttons below to make sure they work. None work, go to How to Scan for TV and VCR Your TV brand from the TV Codes table and goīack to step 3. So, start over from step 3 and try the code If TV light does not flashĪt all, the code may not have been enteredĬorrectly. Light flashes three times, the code is validĪnd you can go to step 8. Note: You have about 20 seconds to begin entering the TV code. Enter one of the three-digit codes for your TV from the TV code tables while TV light is on. You will be referring to this location for codes in the instructions below.Ħ. ![]() Find the brand name of your TV in the TV code tables starting on page 30. After that, you will set up your remote control to work with your TV and then set up. The first thing you will do is make the right connections between the TV and satellite receiver. The following instructions show you how to set up your system and DISH Network EZ Remote Control so that when you press the TV gives you satellite programming every time. Note: If you are installing the satellite receiver for the first time, you must use the remote control that came with your receiver to guide the receiver through the installation procedures, which includes getting the upgrade from the satellite. Note: Check the inside front cover of this guide to see if the remote control is compatible with your satellite receiver. After completing the upgrade, try using the remote control again to make sure it works. To receive this upgrade, turn off your satellite receiver for 20 minutes. If the remote control does not work, your satellite receiver may need to get an upgrade from the satellite. Using your DISH Network EZ Remote Control, press and then try using this remote control to operate some basic satellite receiver features like MENU or GUIDE. ![]() Turn on your TV the way you normally would to watch satellite TV programming. TV TV POWER- Press to turn your TV on or off. OFF-AIR CHANNEL CONTROL - Press to switch your TV to watch programming from your off-air antenna. SATELLITE CHANNEL CONTROL - Press to switch your TV to watch programming from your satellite receiver. ![]() There are some added buttons on this remote control to make operation with your TV easier. See the User’s Guide for your DISH Network satellite receiver for a description of how your satellite receiver works with these buttons. Most of these buttons work the same way as the buttons on other DISH Network remote controls. In addition, the DISH Network EZ Remote Control lets you switch between satellite receiver programming and programming from an off-air antenna with the press of one button.įigure 1 on page iv briefly describes each button on the DISH Network EZ Remote Control. This remote control includes large, easy-to- find buttons which are most commonly used to control the basic satellite receiver features you need. The DISH Network EZ Remote Control makes operating your DISH Network satellite receiver easy and convenient. Setting Up the Remote to Control Your VCR. Setting Up the Remote to Control Your TV. Ĭonnecting Your Satellite Receiver and TV. About the DISH Network EZ Remote Control.īuttons and Features Overview.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |